EMB145飞机加油面板测试步骤图示

lzf08980898 · 发表于 2012-5-13 23:12:06

如何在加油面板上读取不同油箱的油量，如何读取故障代码、如何清除故障代码，每一步都配合照片进行了详细说明，是学习的好材料。

-TEST SELECTION
• When this switch is placed in the TEST position, a display test of the repeater should occur. The display test will illuminate a checkerboard pattern of the LED segments for 2 ±1 seconds, followed by all segments turned off for2 ±1 seconds.
After the display test, all current faults will be displayed as defined in the FAULT CODE table.
• If the TK SEL/TEST switch is again placed in the TEST position during the display test, all stored faults will be displayed as defined in the FAULT CODE table. If there is more than one fault, each fault will appear serially and will remain illuminated for 4 ±1 seconds each.
After showing all the fault codes, thedisplay will blank for 2 ±1 seconds followed by the messageCLEAR ? on the upper display for 10 ±1 seconds.
• If the TK SEL/TEST switch is placed in the TEST position while the message CLEAR? is being displayed, all stored fault
codes should be cleared, and the message CLEARED is activated.
• Once either of these functions is complete, the system should display fuel quantity again.