[知识面拓展] 飞机检查程序 PDF整合版本

EXTERIOR INSPECTION B737-800
Prior to each flight, the flight crew must accomplish or verify that the
maintenance crew has accomplished the following checks :
· ELECTRIC HYDRAULIC PUMP SWITCHES ………………………………….……. ON
- Alert ground personnel before pressurizing hydraulic system
- System A & B pressure 2800 PSI minimum
· PARKING BRAKE ……………………………………………………..………………. SET
- Parking brake warning light (red) illuminated
· EXTERIOR LIGHTS ……………………………………………………..………. STEADY
· WHELL WELL LIGHT ……………………………………………….…………………. ON
- Do not forget to take a flashlight during night time inspection.
PART 1
START
END
Copyright Ó Smartcockpit.com / Ludovic ANDRE 2001
EXTERIOR INSPECTION B737-800
STEP 1
Check Captain Pitot probe
OK & unobstructed
Check Alpha Vane OK
& unobstructed
Check TAT probe OK
& unobstructed
Check no damage
STEP 2
Check lower nose
compartment door
closed
Check Steering Pin
lockout IN or OUT
Check :
1) No hydraulic fluid
leakage on gear
strut (strut not
fully compressed)
2) Taxi light OK
3) Nose-wheel tire
4) Shocks in place
Check no fluid
Leakage & no
damage
STEP 3
Check snubbers
in place
(Left & Right)
Check doors mechanism
& linkage OK (both sides)
STEP 4
PART 2
Copyright Ó Smartcockpit.com / Ludovic ANDRE 2001
EXTERIOR INSPECTION B737-800
STEP 5 5
Check no damage
on dome (conductor
strip in good condition)
Both wipers in place
Windshield in good
condition
STEP 6
Check F/O
emergency handle
in position.
Check Pitot Probes
& Alpha Vanes OK
& unobstructed.
Check GPU correctly
connected.
If not used, check
door is properly
closed.
Check no fluid
Leakage & no
Damage
Tire in good
condition
Max tow angle
sticker for tug
driver.
STEP 7
Check CAPT &
F/O Static ports
(Clean & no
damage)
STEP 8
PART 3
STEP 9
Check Cargo compartments
(no leakage, no damage, no
suspect luggage, lights
operating normally)
Check door operating normally
Check alternate static port
(clean & no damage)
Check Oxygen pressure relief
green disc in place (not visible
on this picture)
Check antenna in place under the fuselage
(not visible on this picture)
Copyright Ó Smartcockpit.com / Ludovic ANDRE 2001
EXTERIOR INSPECTION B737-800
STEP 10
PART 4
Check Turn off & Fixed Landing lights in good
condition
Check Ram air deflector door extended & not
obstructed
Check Drain mast
Check equipment cooling exhaust door under
the fuselage (closed)
STEP 11 2
STEP 12 2
Check Wing surfaces are clear of ice, snow or
frost.
Check Leading edge flaps
Check Gear strut not fully compressed &
door in place.
Check tire in good condition
No structural damage.
Check Vortex in place
No structural damage on engine.
Check IDG access door fully closed
+ Engine cowl latch
Check Landing light in good
condition
Copyright Ó Smartcockpit.com / Ludovic ANDRE 2001
EXTERIOR INSPECTION B737-800
STEP 13
PART 5
STEP 14 2
STEP 15 2
Check no structural damage.
Check maintenance door fully closed
Check reverse sleeves in position (black
stickers in front of each other)
Check Wing surfaces are clear of ice, snow or frost.
Visually inspect the lower wing surface. If there is frost or
ice on the lower surface outboard of measuring stick 4,
there may also be frost or ice on the upper surface. The
distance that frost extends outboard of measuring stick 4
can be used as an indication of the extent of frost on the
upper surface.
Note : Takeoff with light coating of frost, up to 3 mm (1/8 inch) in
thickness on lower wing surfaces due to cold fuel is permissible.
However, all leading edge devices, all control surfaces, tab surfaces,
upper wing surfaces and balance panel cavities must be free of snow
or ice.
Check Leading Edge slats in good condition
Check Vortex in place
No structural damage.
Check fan blades in good condition (no fan
blade damaged) & turning normally (anticlockwise)
Check no suspect leakage under the engine
Copyright Ó Smartcockpit.com / Ludovic ANDRE 2001
EXTERIOR INSPECTION B737-800
STEP 16
PART 6
STEP 14 2
STEP 15 2
Check wingtip
White Strobe lights & Green position lights
OK & cover in place.
Check aileron & tab
Check 4 static dischargers in good condition
Check trailing edge flaps (no structural damage ).
Check Ram air vent scoop non obstructed
Check refuelling panel access door in
position (defueling panel should be closed)
Fuel measuring sticks retracted & agree with
alignment marks
Copyright Ó Smartcockpit.com / Ludovic ANDRE 2001
EXTERIOR INSPECTION B737-800
STEP 17 PART 7
STEP 18 2
STEP 19 2
Check Ground locking pin
Check :
- Tire condition
- Check strut extension (not fully compressed) = approx. 3 fingers
Check all 4 brake wear pins
Check no structural damage.
Check damaged tread impact fitting (in place)
Check Main Landing Gear Pin lockout OUT
Check all tire bolts in place
Check aileron & tab in good condition
Check Flaps in good condition
Brake wear pins
Copyright Ó Smartcockpit.com / Ludovic ANDRE 2001
EXTERIOR INSPECTION B737-800
STEP 20 PART 8
STEP 21 2
STEP 21 2
Check System B hydraulic reservoir (no leakage)
Check System B hydraulic reservoir quantity indicator (RF or above)
Check System A hydraulic reservoir (no leakage)
Check System A hydraulic reservoir quantity indicator (RF or above)
Check APU Fire Warning Horn in place
Check APU Fire Warning Handle (sealed & UP)
Check Standby hydraulic system reservoir (no leakage)
Check Brake accumulator indicator (2800 PSI minimum)
STEP 22 2
Check Aft Cargo Compartment
(no leakage, no damage, no suspect luggage,
lights operating normally)
Check door operating normally
Check lower beacon in good condition
Copyright Ó Smartcockpit.com / Ludovic ANDRE 2001
EXTERIOR INSPECTION B737-800
STEP 23
PART 9
Check APU Air Inlet Door in good condition (OPEN)
Check Negative Pressure Relief Valves (CLOSED)
Check Pressure Relief Valves in good condition (UPPER & LOWER)
Check Outflow Valve in
good condition
(FULL OPEN)
Check Aft Water Drain
Mast in good condition.
Check Tail Skid
(Green Warning Decal
in view. If not, call
maintenance crew)
Check Elevators & Tabs (LEFT &
RIGHT)
Check :
- APU Cooling Air Inlet (UPPER)
- APU Exhaust Air Outlet (LOWER)
- APU access door closed
- Tail cone strobe light in place
- Water service door closed
Check Rudder Static Dischargers
(total of 4)
Check Elevators Static Dischargers
(3 LEFT + 3 RIGHT = 6)
Check Elevator Pitot Probes (LEFT + RIGHT)
Not visible on this picture
STEP 24
Copyright Ó Smartcockpit.com / Ludovic ANDRE 2001
EXTERIOR INSPECTION B737-800
STEP 25
PART 10
Check Aft Heated Water Drain Mast in good
condition
STEP 25
Check APU Shroud & Hydraulic Drain
in good condition
STEP 25
Check Both Engine Fire Extinguishers Pressure in RIGHT
wheel well
OAT Mini PSI Maxi PSI
-20°C 515 665
0°C 605 755
+20°C 735 890
+40°C 935 1095
PROCEED ON LEFT WING / LEFT ENGINE / LEFT
FUSELAGE AS SHOWED ON PREVIOUS PICTURES
Copyright Ó Smartcockpit.com / Ludovic ANDRE 2001