请选择 进入手机版 | 继续访问电脑版

机务在线

搜索
查看: 4826|回复: 5

航空英语集锦(二)

[复制链接]

14

主题

980

帖子

555

积分

机务学徒工

Rank: 3Rank: 3

积分
555
发表于 2022-9-1 16:09:12 | 显示全部楼层 |阅读模式 来自: 中国湖北
E
12. Every time he comes up with a new idea, he writes it down in his notebook. B
A: Every time he comes under a new idea, he writes it down in his notebook.
B: Every time he thinks of a new idea, he writes it down in his notebook.
C: Every time he comes in a new idea, he writes it down in his notebook.
34.Each electrical system has a code to identify it. A
A:Each electrical system is identified by a code.
B: Each code of electrical system id identified.
C: Each system is identified by an electrical code.
57. Each system/Chapter/Section will start with a new block of page numbers. B
A: When you prepare each system/Chapter/Section, you can continue to use the page numbers previously-used.
B: Each system/Chapter/Section will use a new block of page numbers as a beginning.
C: The beginning of each system/Chapter/Section shall list a new block of page numbers.
67. Each radio altimeter transceiver sends radio altitude data to the on-side AFDC. C
A: The left radio altimeter transceiver sends radio altitude data to the right AFDC.
B: The left radio altimeter transceiver sends radio altitude data to both the left and right AFDC.
C: The left radio altimeter transceiver sends radio altitude data to left on-side AFDC.
84. Entrance stairs or step operate in conjunction with but are not integral part of entrance doors. C
A: Entrance stairs or step are connected with entrance doors and move accordingly.
B: Entrance stairs or step are integrated with entrance doors and operate together.
C: Although entrance stairs or step operate together with entrance doors, they are not integrated.
114. Each multi-mode receiver (MMR) sends runway course and ILS deviation data to the on-side AFDC. A
A: The left multi-mode receiver (MMR) sends runway course and ILS deviation data to the left AFDC.
B: The left multi-mode receiver (MMR) sends runway course and ILS deviation data to the right AFDC.
C: The left multi-mode receiver (MMR) sends runway course and ILS deviation data to both the left and right AFDC.
F
6. Fabric punch tester is a device used to determine the relative strength of the fabric covering on an aircraft. The tester can give a general idea of the strength without cutting a sample of the fabric or removing the finish. C
A: It is required to get a sample of the fabric without finish for the fabric punch tester.
B: Fabric punch tester is a device used to determine the strength of the fabric covering on an aircraft, which can get very accurate result.
C: Fabric punch tester is used to determine the relative strength of aircraft fabric.0
39. Flaperon is aircraft controls used on some swept wing airplanes that serve as both ailerons and wing flapsB
A: Flaperon plays the role of both ailerons and spoiler On some swept wing airplanes.
B: On some swept wing airplanes, Flaperon functions both ailerons and flaps. o
C: Flaperon is aircraft controls used on some swept wing airplanes that serve as both elevator and wing flaps
90. For the purposes of range computations and related weight statements, the density of aviation gasoline shall be taken as 6.0 LBS U.S. Gal. and for aviation kerosene as 6.7 LBS U.S. Gal. C
A: The aviation gasoline is usually used for the turbine engine.
B: The aviation kerosene is usually used for the piston engine.
C: The aviation kerosene is usually used for turbine engine.
117. Functional tests, which is more specific than the operational test, requires supplement ground equipment to be done and ascertain a system or unit is functioning in all aspects according to minimum acceptable design specifications.B
A: Operational test is more complex and specific than the functional test.
B: Functional tests require supplement equipment to be done.
C: Functional test is used to ensure a unit is functioning in all aspects in according to maximum acceptable design specifications.
G
19. Give temporary protection to areas of bare metal since bare metal surfaces are usually satisfactory for an electrical bond. If there is corrosion on the surfaces, it will cause severe problems. C
A: Give long term protection to areas of bare metal since bare metal surfaces are usually unsatisfactory for an electrical bond. If there is corrosion on the surfaces, it will cause severe problems.
B: Give temper protection to areas of bare metal since bare metal surfaces are always satisfactory for an electrical bond. If there is corrosion on the surfaces, it will cause severe problems.
C: Protect the bare metal areas temporarily since this kind of surfaces are usually adequate for an electrical bond. If corrosion happens on the surfaces, it will bring serious problems.
21.Good technical writing uses short sentences for all types of topics (simple and complex). Short sentences make your writing stronger and information easier to understand. In descriptive writing, the maximum sentence length is 25 words. B
A: Descriptive sentence must have as many as 25 words.
B: Descriptive sentence contains no more than 25words.
Cescriptive sentence should contain at least 25 words.
20. However, it is not often the native language of the readers of technical documentation. A
A: However, it is not often the mother language of the readers of technical documentation. B: However, it is not often the private language of the readers of technical documentation.
C: However, it is not often the primary lanquage of the readers of technical documentation.
28.-Hi, Tom, What's going on over there?
-Oh, Smoke comes out of the cargo compartment. The fire department has arrived. B
A: -Hi, Tom, What's appearing over there?
-Oh. Smoke comes out of the cargo compartment. The fire department has arrived.
B: -Hi, Tom, What's happening over there?
-Oh, Smoke comes out of the cargo compartment. The fire department has arrived.
C: -Hi, Tom, What's working over there?
-Oh. Smoke comes out of the cargo compartment. The fire department has arrived.
58.Head aircraft into the wind C
A: Top into the wind
B: Aft into the wind
C: Point the aircraft into the wind
79. Having reached the airport, he found that the airplane had taken off. A
A: After he reached the airport, he found he was too late to catch the airplane.
B: Having reached the airport, he found the airplane would take off.
C: Having reached the airport, he found the airplane was taking off.
134. Go-around arms when the airplane is in the air and, one of these conditions is true: Glideslope mode is active The trailing edge flaps are not up.A
A: Go-around arms when the airplane is in the air and trailing edge flaps are not up.
B: Go-around arms when glideslope mode is active and the trailing edge flaps are not up.
C: Go-around arms when the airplane is in the air and trailing edge flaps are in the up position.
150. Galley ventilation filters are line replaceable. Remove the lens assembly and the retainer to remove the filter.B
A: You need to use lens assembly and retainer as tooling to removed the filter.
B: Galley ventilation filters can be replaced by mechanic in the line maintenance.
C: Galley ventilation filters can not be replaced by mechanic in the line maintenance.

回复

使用道具 举报

1

主题

20

帖子

330

积分

机务学徒工

Rank: 3Rank: 3

积分
330
发表于 2022-9-2 07:11:30 来自手机 | 显示全部楼层 来自: 中国广东揭阳
回复 支持 反对

使用道具 举报

0

主题

1

帖子

54

积分

试用期机务

Rank: 1

积分
54
发表于 2022-9-5 21:52:22 | 显示全部楼层 来自: 中国北京
楼主只到G,后面还有没有呀,感谢分享
回复 支持 反对

使用道具 举报

7

主题

51

帖子

304

积分

机务学徒工

Rank: 3Rank: 3

积分
304
发表于 2022-10-9 13:37:11 | 显示全部楼层 来自: 中国陕西西安
大哥,怎么不发了,继续啊
回复 支持 反对

使用道具 举报

0

主题

15

帖子

0

积分

试用期机务

Rank: 1

积分
0
发表于 2022-10-11 10:03:53 | 显示全部楼层 来自: 中国广东广州
学习学习
回复

使用道具 举报

0

主题

16

帖子

622

积分

机务正式工-无执照

Rank: 4

积分
622
发表于 2022-11-1 12:22:55 来自手机 | 显示全部楼层 来自: 中国北京
这是书上的?还是原题?
回复 支持 反对

使用道具 举报

您需要登录后才可以回帖 登录 | 立即注册

本版积分规则

快速回复 返回顶部 返回列表