大神求助：驾驶舱里手动调节外流活门

傻乎乎 · 发表于 2016-3-27 21:04:53

大神求助：驾驶舱里选择人工模式，手动调节外流活门，为什么无法完全关闭?

zhao8831 · 发表于 2016-3-27 23:29:16

按水上迫降电门就完全关闭了

傻乎乎 · 发表于 2016-3-29 23:33:56

zhao8831 发表于 2016-3-27 23:29
按水上迫降电门就完全关闭了

不按水上迫降按钮就无法完全关闭，是怎么回事啊，飞机在地面的时候？

csair--wbh · 发表于 2016-3-30 17:13:55

学习了！！！！

zhao8831 · 发表于 2016-4-4 22:14:45

傻乎乎发表于 2016-3-29 23:33
不按水上迫降按钮就无法完全关闭，是怎么回事啊，飞机在地面的时候？

一般都是开着的吧

xqloswang · 发表于 2016-4-4 22:15:52

洗飞机就要关

cxw802844 · 发表于 2016-4-8 11:25:32

大概是因为RPCU的跳开关没有拔出来

夜尽天明月 · 发表于 2016-5-4 15:45:21

C. Manual Operation
The cabin pressure can be controlled manually from the CABIN PRESS overhead panel 25VU. When the MODE SEL pushbutton switch is released to the MAN position and the MAN V/S CTL switch is set to UP or DN, the manual motor and the gearbox moves the outflow valve flaps to the commanded position.
The feedback module sends position signals to the backup part of the CPC 1 for indication.
The backup part gives the excess cabin altitude and the pressure data to the EIS. The data is shown on the PRESS page of the ECAM lower display unit.

If the crew cannot control the cabin pressure manually, the RPCU will open the outflow valve automatically under these conditions:
· The outflow valve is not fully open
· Both landing gears are on ground or one landing gear is on ground and the park brake is applied
· All engine master lever switches are in the OFF position or all air data units show speed below 100 knots
· The two CPCs are in standby fail or on manual mode.

(3) V/S CTL Toggle Switch
The switch, spring loaded to neutral,controls the outflow valve with the manual motor, when the MODE SEL pushbutton switch is in the MAN position.
· UP : The outflow valve move towards the open position,
· DN : The outflow valve move towards the closed position.
人工调节外流活门，DOWN位朝着关位靠拢，不能完全关闭。To target precise cabin vertical speed rate, only short inputs should be applied on the
toggle switch.

wenye同学 · 发表于 2016-5-4 19:32:13

长知识都是大神

gtq · 发表于 2016-5-5 15:56:11

学习了，谢谢！

傻乎乎 · 发表于 2016-5-15 22:41:06

cxw802844 发表于 2016-4-8 11:25
大概是因为RPCU的跳开关没有拔出来

牛逼，昨晚航后就按照你的方法拔了跳开关，确实可以完全关闭了。

帐号		自动登录	找回密码
密码			立即注册

[21空调] 大神求助：驾驶舱里手动调节外流活门

实名认证

TAECO

成都航空

中国民航大学